G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 134

Initial configuration of the network settings
Configuring the network interface
How to configure the network interface:
1. Use the
local hotkey
work interface of the console module or use the
open the remote OSD to configure the network interface of the computer module.
2. Select the entry
Enter .
3. Select the entry
4. Enter the following data under
Operational
mode:
IP address:
Netmask:
5. Press F2 to save your settings.
22 · G&D VisionXS-F-DP-UHR
(default: +
Alt Num
Network (local OSD) or
Interfaces and press
Interface A
Press F8 to select the operational mode of the interface:
 Off: switch network interface off.
A static IP address is assigned.
 Static:
IP address is obtained from a DHCP server.
 DHCP:
Enter the IP address of the interface.
The operational mode DHCP does not allow making entries.
Enter the netmask of the network.
The operational mode DHCP does not allow making entries.
) to open the local OSD to configure the net-
remote hotkey
Network setup (remote OSD) and press
Enter .
:
(default: + ) to
Ctrl Num