G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 122

Installation
Establishing a connection to the console module
Transmission 1 Transmission 2 Transmission 2
Service Service
IMPORTANT:
The devices use components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE: Remove the protection caps from the Transmission interfaces and from the
cable plug.
Transmission 1|Tx: Insert the LC plug of a fibre optic cable, which is available as
accessory, into this interface. Connect the other end to the Transmission|Rx interface
of the console module or to one of the Dynamic Ports of a compatible matrix (see
page 5).
Insert the LC plug of a fibre optic cable, which is available as
Transmission 1|Rx:
accessory, into this interface. Connect the other end to the Transmission|Tx interface
of the console module or to one of the Dynamic Ports of a compatible matrix (see
page 5).
NOTE: The activation of the
interface.
To use the
Transmission 2
Choose the right
The Transm. Redundancy options
Transm. Redundancy
Use the
Transmission 2
part.
10 · G&D VisionXS-F-DP-UHR
Network Network Pwr Main Power Pwr Main Power
Transm. Redundancy
interface, you need an additional SFP transceiver.
for your variant of the
SFP transceiver
contain both, a corresponding
feature.
interface to establish a connection with a second counter-
Red. Power Red. Power
feature activates the
VisionXS-F-DP-UHR
SFP transceiver
Transmission 2
series.
and the