G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 184

Configuration
Freeze mode
If the cable connection between the computer module and the console module is inter-
rupted during operation, the KVM extender no longer displays an image at the remote
console.
Enable the Freeze mode if you want the last image that has been displayed at the console
module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a
connection has been interrupted.
How to configure the Freeze mode:
1. Press
Ctrl+Num
2. Select the row
The following options can be adjusted separately for both video channels, if you use the
optional Transm. Redundancy feature
3. Under Freeze mode
off  Freeze mode is disabled (default)
on  Freeze mode is enabled
4. If the Freeze mode is active, press
under
Freeze visualization
frame
OSD
frame+OSD
5. Press F2 to save your settings.
72 · G&D VisionXS-F-DP-UHR
(default) to open the OSD.
Console setup and press
press F8 to select on of the following options:
:
 shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
 shows a coloured frame (
Frozen popup and the time passed since the
Enter .
.
to select one of the options available
F8
) and Frozen (
frame
)
OSD