G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 129

Start-up
After the proper installation of the KVM extenders they can be immediately put into
operation.
Mind the following activation sequence when starting the modules:
1. Switch on the external power supply of the
or switch on the internal power supply (DT variant only).
2. Switch on the external power supply of the
or switch on the internal power supply (DT variant only).
3. Turn on the computer
NOTE:
The recommended activation sequence ensures that the KVM extenders
are able to read out the features of the connected monitor and to transmit them to
the computer (see DDC transmission with cache function on page 87).
Starting process
After the computer module and the console module are turned on, the LEDs on the
back panel show the module's operating status.
For further information about this topic, also see the chapter Status LEDs on
page 89 ff.
Operation
IMPORTANT:
The OpenAccess operating mode is set by default. In this operating
mode, access to the KVM extender is not protected by authentication. Information
on the operating modes can be found in chapter Operating modes of console modules
on page 55 ff.
You can operate the computer connected to the
the remote console of the console module.
NOTE: The connection between the computer module and the console module is
established automatically after the modules are started.
NOTE:
The activation of the
interface.
To use the Transmission 2
Choose the right SFP transceiver
The
Transm. Redundancy options
Transm. Redundancy feature.
Use the Transmission 2
part.
that is connected to the computer module.
Transm. Redundancy
interface, you need an additional SFP transceiver.
for your variant of the
contain both, a corresponding
interface to establish a connection with a second counter-
console module
computer module
computer module at
VisionXS-CPU
feature activates the
VisionXS-F-DP-UHR
SFP transceiver
G&D VisionXS-F-DP-UHR · 17
Start-up
Transmission 2
series.
and the