G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 182

Configuration
Selecting the EDID mode of the KVM extender
EDID information (Extended Display Identification Data) of a monitor informs the gra-
phics card of a connected computer about different technical device features. The
information is usually transmitted via Enhanced-DDC (Enhanced Display Data Chan-
nel) and without any alteration between KVM extender and computer.
NOTE: For initial operation and when connecting another monitor, please follow
the activation sequence recommended on page 17.
Special GUD profiles are provided for some resolutions. The names of these profiles
contain information about the preferred resolution that is transmitted to the graphics
card of the computer when using this profile.
As an alternative, you can use the web application
profile of a monitor. The KVM extender then transmits it to the connected com-
puter. Detailed information about this topic is given in the separate manual of the
web application Config Panel
How to select the EDID mode of KVM extenders:
1. Press
Ctrl+Num
2. Select the row
3. Under
EDID mode
 automatic treatment of EDID data (default)
auto
 use of a G&D profile or a profile that has been read out via
user
web application
4. If the option
Use the arrow keys
Save your selection by pressing
5. Press to save your settings.
F2
70 · G&D VisionXS-F-DP-UHR
.
(default) to OSD.
Target setup and press
press to select on of the following options:
F8
user has been selected, select the row
to select the profile you want the activate and press
Config Panel
Enter .
Assign EDID
F2 .
to read out the EDID
and press Enter
F8 .
.