Parkside PHDP 180 C2 Originalbetriebsanleitung Seite 38

GB MT
Interrupting the operation
You can insert the trigger gun (1) with
lance and nozzle into the holder for the
trigger gun (31).
1. Release the switch lever (17) on the
trigger gun (1).
If you put down the trigger gun: Lock
2.
the switch lever using the child safety
lock (18) (seen from behind).
⭠ The switch lever is locked ὑ.
⭢ You can pull the switch lever ὑ.
WARNING! Risk of injury due to
pressure jet! Lock the switch lever every
time you take a break.
3. When taking longer breaks: Move the
On/Off switch (32) to the position
"0" (OFF).
Bleeding
Bleeding the supply hose
1. Close the tap.
Remove the supply hose from the
2.
device.
3. For more, see Establishing a water sup-
ply, p. 34
Bleeding the device
1. Move the On/Off switch (32) to the
position "I" (ON).
Wait until pressure has built up and the
2.
motor stops.
Move the On/Off switch (32) to the
3.
position "0" (OFF).
Press the switch lever (17) on the trig-
4.
ger gun (1) until the pressure has been
released.
5. Repeat these steps several times until
there is no more air in the device.
Ending the operation
1. After working with cleaning agents:
• Empty the cleaning agent tank (13).
38
• Rinse the device with clear water
until the lines are free of cleaning
agent.
Release the switch lever (17).
2.
Move the On/Off switch (32) to the
3.
position "0" (OFF).
Close the tap.
4.
Press the switch lever (17) on the trig-
5.
ger gun (1) until the pressure has been
released.
Pull out the plug. Wind the mains con-
6.
nection cable (10) on the holder (11).
7. Disconnect the device from the water
supply.
Cleaning, maintenance
and storage
WARNING! Electric shock! Protect
yourself when performing maintenance or
cleaning work. Turn off the device. Pull out
the mains plug.
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
NOTICE! Risk of damage! Improper
cleaning can damage the device. Never
spray down the device with water. Do not
clean the device under running water. Do
not use any abrasive cleaning agents or
solvents.
Always keep the device clean.
Cleaning after operation
1. Move the On/Off switch (32) to the
position "0" (OFF).
Pull out the plug.
2.
Keep the ventilation slits clean and free
3.
of objects.