Switching On; Interrupting Operation; Operation; Cleaning Using Cleaning Agent - Parkside PHD 135 D3 Originalbetriebsanleitung

Operation

Cleaning using cleaning agent

Requirements for the cleaning agent
• This device has been designed to be used
with a neutral cleaning agent based on bio-
degradable anionic surfactants.
• Use of other cleaning agents or chemicals
can negatively impact the safety of the de-
vice and can cause damage. Such damage
to the device is not covered by the warranty.
• You can buy cleaning agents from our on-
line shop.
Requirements
• The cleaning agent tank is filled with clean-
ing agent.
• The tip of the standard Vario nozzle is moved
to the front.
Filling and emptying the cleaning agent
tank
1. Remove the sealing cap with suction hose (7)
from the cleaning agent tank
2. Pull the cleaning agent tank (8) upward and
then to the front.
✔ The cleaning agent tank is removed. You
can fill or empty the cleaning agent tank.
3. Insert the cleaning agent tank in reverse or-
der.
4. Seal the cleaning agent tank with the seal-
ing cap.
5. Push the suction hose into the cleaning agent
tank until it reaches the bottom.

Switching on

⚠ WARNING! A leaky water system can result
in electric shock! Move the On/Off switch (2)
to the "O" (OFF) position. Unplug the plug. Try
connecting the water connection again (see Con-
necting the water supply, p. 54).
⚠ WARNING! The device may only be used in
an upright position! There is a risk of an electric
shock if the device falls over. Turn the device off
immediately using the On/Off switch (2). Unplug
the plug. Only now may you bring the device
into the upright position. For your own safety,
wait about five minutes until you restore the elec-
trical connection.
⚠ WARNING! Unsuitable extension cables
can be dangerous! Use only extension cables
that are designed for outdoor use. The connec-
tion must be dry and routed above the ground.
We recommend using a cable drum that holds
the socket at least 60 mm above the ground.
1. Ensure that the On/Off switch (2) is in the
"O" position.
2. Insert the mains plug into an earthed socket
with residual current circuitry.
3. Put the device in an upright position.
4. NOTE! Dry running will damage the device.
Do not operate the pressure washer with the
tap turned off.
Turn the tap on fully.
5. Move the On/Off switch (2) to the "I" (ON)
position.
6. The motor starts briefly to build pressure.
Once the necessary pressure has been built,
the motor stops.
7. ⚠ WARNING! Be aware of the recoil force
when the water jet commences. There is a risk
of injuring yourself or other people. Ensure
that your footing is secure. Keep a good hold
on the pistol grip (1).
Press the switch lever (13) on the pistol grip
(1).
✔ The nozzle works with pressure and the
motor starts. If you release the switch lever
(13), the motor will stop. The high pressure is
maintained in the system.

Interrupting operation

1. Release the switch lever (13) on the pistol
grip (1).
2. If you put down the pistol grip: Lock the switch
lever using the child safety lock (16) (seen
from behind).
⭠ The switch lever is locked ��.
⭢ You can pull the switch lever ��.
GB MT
55