Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring the software
e. Auto configuration: this step is not required if power is
applied to CSNET WEB after all the refrigerant circuits
that you want to control have been activated. If this is not
the case, it is advisable to activate auto-configuration. The
following three options are available:
-
Keep all: keeps all the machines that were previously re-
gistered (although they weren't found), and adds the new
ones.
-
Delete not found: deletes all the machines that were pre-
viously registered (unless they were found), and adds the
new ones.
-
Delete all: deletes all the machines that were previously
registered and adds the ones it has found.
Select the option and click Start to start unit recognition.
f. Time configuration: enter the date and time. Always res-
pect the indicated format: "yyyy/mm/dd hh:mm"
Select the geographical area nearest the installation.
Click Change to update CSNET WEB time and time zone.
g. Ethernet Gateway: you can change the IP and MAC val-
ues of your Gateway here by clicking the button Change.
h. BMS configuration:
1 Modbus Configuration: CSNET WEB enable to confi-
gure the BMS system setting id for each indoor unit.
This configuration will link the BMS with the H-LINK.
To start the BMS configuration click on the change
button.
CSNET WEB automatically assigns an ID for each
found unit. You can change this ID on the table.
The ID field can not be repeated, if it will occur, CS-
NET WEB will ask you to change the repeated ID.
BMS communication could be watched using BMS
monitor button.
2 Fidelio Configuration: CSNET WEB is compatible
with a Hitachi H-LINK to Fidelio Gateway.
Each unit can be linked to a Fidelio register to now
if there is a check in or check out condition on that
room.
For each unit can be assigned a pattern similar to
the timer one that describes a condition for check in
and another for check out. It also can be specified the
data period where that patterns applies.
To activate the Fidelio compatibility it must be selec-
ted the check box and specified an accessible IP for
the Hitachi Fidelio gateway.
C A U T I O N
Actions configured on the Fidelio dialog are managed
from the CSNET WEB client software, so it is neces-
sary to have the computer program running to use the
Fidelio compatibility.
13
PMML0164A rev.2 - 10/2012
Werbung
