Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring the software
6.1 CONFIGURING THE NETWORK
Initial system configuration is performed using the buttons at the
bottom left part of CSNET WEB's main window
Click on Configure System to initiate the configuration of the
System.
a. Network settings: You must adapt the configuration of
CSNET WEB to that of the network it is connected. The
data you enter must match the network's configuration.
Click Change to open the window for change the data.
C A U T I O N
• Very important: The IP, Mask and Gateway parameters
were already cofigured when you used the CD-ROM. In
any case, they may be modified again as shown below.
• Remember that, once they have been modified, you
will be disconnected and you wil have to reconnect by
changing the previous IP to the new address.
N O T E
You must always refer to the person in charge of the
computer system CSNET WEB connects to concer-
ning this configuration. Once you have changed the
IP configuration, you must restore the PC's confi-
guration to ensure that it is in the same network as
CSNET WEB and thus reconnect with the new IP.
It is advisable to change it only after all other configura-
tions have been completed.
b. Version and updates:
information to the user about which software is insta-
lled on the HARC.
configured, it can download updates for the HARC and
install them just by clicking the button.
C A U T I O N
HARC cannot be updated through a proxy.
c. Change password: The Change button beside Pas-
sword setting opens the Change password panel.
To change your password:
-
Enter the installer password. (The default factory pas-
sword is "Installer").
-
Enter the new password.
-
Repeat the new password to confirm it.
-
Click the "OK" button to validate the changes and return to
system configuration window.
N O T E
Only Installer password may be changed for CSNET WEB
Server. User password will no longer be used for CSNET
WEB Server.
d. Installation name: Enter a name that identifies the insta-
llation or the building. Click 'Change' to update it.
12
Version and updates gives the
If the internet connection is properly
PMML0164A rev.2 - 10/2012
Werbung
