Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuring the hardware
5.1.2 Connecting to CSNET WEB to configure the
software
This option lets you change the PC network settings temporarily
and connect to the CSNET WEB interface.
C A U T I O N
We recommend that you do not configure the software without
configuring the CSNET WEB interface first.
1 Select Connect to CSNET WEB for Configuration, press
Next and the Select Network Card window appears, showing
the network adaptors available in your PC.
2 Select the network adaptor you are going to use and press
Next.
We recommend you choose Local area connection if the
system does not already have a specific network (the network
administrator will help you make the correct choice).
3 Introduce the IP of the CSNET WEB you want to connect to.
The configuration you have already chosen appears by de-
fault. You should always introduce the temporary IP the PC
has to use.
C A U T I O N
If the PC and CSNET WEB interface are connected to a local
area network, the network configuration should be supplied
by the network administrator. Otherwise, use a valid confi-
guration within the range set for the CSNET WEB interface.
In case of doubt, consult the network administrator.
4 Press Next to validate the changes, change the PC network
configuration temporarily and start the CSNET WEB applica-
tion which configures the system.
5 When the application starts it configures the system as indica-
ted in chapter Configuring the Hardware.
6 After completing the configuration close the CSNET WEB
application and choose OK in the message Waiting for CS-
NET WEB to finish.... The installation will return to its initial
screen.
8
OK
PMML0164A rev.2 - 10/2012
Local area connection
< Back
Next >
Cancel
< Back
Next >
Cancel
< Back
Next >
Cancel
Werbung
