Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Maintenance
5.7 Maintenance work — Yanmar
Only the maintenance work which has to be performed daily
is included in this operating manual. Please refer to the en-
gine operating manual and to the maintenance instructions
and intervals listed therein.
5.7.1 Filling up with fuel
Only top-up by stationary engine.
No open fire.
Danger
Do not smoke.
Do not fill-up in closed rooms.
Do not inhale petrol fumes.
Collect spilt fuel in a suitable container and pre-
vent spillage entering the soil.
MAX
L 40_011.cdr
–
Clean around the fuel filler socket.
–
Open the fuel filler socket and
–
Visually check the fuel level. An unusable amount of fuel re-
mains in the tank due to the design.
–
Top-up if necessary; all diesel oils sold as fuel and complying
with the following minimum specification can be used: EN 590;
DIN 51601 - DK; BS 2869 A1 / A2; ASTM D 975 - 1D / 2D.
–
Close the tank tightly.
5.7.2 Checking the engine oil level
Immediately replace damaged seals.
Collect old oil and dispose of it in an environment
Attention
friendly manner.
Do not permit oil to run onto the floor into the
drains.
OIL
SAE 10W/40
1
MAX
MIN
B1399012.cdr
–
Park the machine horizontally.
–
Clean the area around the fuel filler cap.
–
Open the fuel filler cap (1).
–
Simply dip the dipstick into the oil pan; do not screw in the dip-
stick.
–
Check the oil level and refill up to the edge of the fuel filler cap
(MAX) if necessary.
–
Check the seal on the dipstick and replace if necessary.
–
Close the fuel filler cap.
57
Werbung
