Herunterladen Diese Seite drucken

Ammann AVP 1240-2 Originalbetriebsanleitung Seite 58

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5. Maintenance
5.5 Maintenance work — Hatz
Only the maintenance work which has to be performed daily
is included in the Operating Manual. Please refer to the en-
gine Operating Manual and to the maintenance instructions
and intervals listed therein.
5.5.1 Filling up with fuel
Only top-up by stationary engine.
No open fire.
Danger
Do not smoke.
Do not fill-up in closed rooms.
Do not inhale petrol fumes.
Collect spilt fuel in a suitable container and pre-
vent spillage entering the soil.
1
B1799213.cdr
Clean around the fuel filler socket.
Open the fuel filler socket and
Visually check the fuel level. An unusable amount of fuel re-
mains in the tank due to the design.
Top-up if necessary; all diesel oils sold as fuel and complying
with the following minimum specification can be used: EN 590;
DIN 51601 - DK; BS 2869 A1 / A2; ASTM D 975 - 1D / 2D.
Close the tank tightly.
5.5.2 Checking Cooling air-/combustion air-intake
Check intake opening for combustion air and cooling air intakes.
Remove coarse ostructions such as leaves, stones and earth.
l
max. 3
/
0,79 US gal
1B20_3.cdr
53
5.5.3 Checking the engine oil level
Collect old oil and dispose of it in an environment
friendly manner.
Environment
Do not permit oil to run onto the floor into the
drains.
Immediately replace damaged seals.
1
1B20_5.cdr
Position the vibration plate so that the engine is in vertically
upright position.
Clean around the dipstick area.
Pull out dipstick (1) and wipe clean.
Push dipstick back in with twisting movement by hand, then
pull out again with similar twisting movement.
Read off the oil level on the dipstick, and if necessary top to
the «max» mark.
5.5.4 Check the water trap
3
Check the water trap on its water content every day, when the en-
gine oil level is checked. The water which has collected is sepa-
rated at a clearly visible line from the diesel fuel above it.
Open drain plug (3) and
drain the water outinto a suitable vessel.
max
OIL
SAE 10W/40
B5399027.cdr

Werbung

loading

Diese Anleitung auch für:

Avp 1250-2Avp 1850-2