Ammann AVP 1240-2 Originalbetriebsanleitung Seite 60

5. Maintenance
5.6 Maintenance work — Honda
Only the maintenance work which has to be performed daily
is included in the Operating Manual. Please refer to the en-
gine Operating Manual and to the maintenance instructions
and intervals listed therein.
5.6.1 Filling-up with fuel
Only top-up by stationary engine.
No open fire.
Danger
Do not smoke.
Do not fill-up in closed rooms.
Do not inhale petrol fumes.
Collect spilt fuel in a suitable container and pre-
vent spillage entering the soil.
GX 120_010.cdr
– Stop the engine.
– Clean around the fuel filler socket.
– Open the fuel filler socket and visually check the fuel level. Re-
fill the tank if the fuel level is low.
Never use stale or contaminated gasoline or an
oil/gasoline mixture. Avoid getting dirt or water in the
fuel tank.
Important
– Add fuel to the bottomof the maximumfuel level limit of the fuel
tank. Do not overfill. Use unleaded automotive gasoline only.
– Wipe up spilled fuel before starting the engine..
– Close the tank tightly.
NORMAL
STANDARD
NORMALE
MAX
l
(2.5 /
0.66 US gal)
5.6.2 Checking the engine oil level
Immediately replace damaged seals.
Collect old oil and dispose of it in an environment
friendly manner.
Environment
Do not permit oil to run onto the floor into the
drains.
– Stand the machine horizontally.
– Stop the engine.
1
B4899014.cdr
– Remove the oil filler cap/dipstick (1) and wipe it clean.
– Insert the oil filler cap/dipstick (1) into the oil filler neck as
shown, but do not screw it in, then remove it to check the oil
level.
– If the oil level is near or below the lower limitmark on the dip-
stick, fill with the recommended oil to the upper limit mark (bot-
tom edge of the oil fill hole). Do not overfill.
– Reinstall the oil filler cap/dipstick (1).
55
OIL
SAE 10W/40
MAX
MIN