Indicating The Time/Date For The Single Extreme Value - Conrad WS222 Bedienungsanleitung

Proceed as follows for calling up the saved data:
• Calling up minimum values
Press the MIN/MAX key. MIN appears in the centre of the display.
Now, the minimum values are indicated in the corresponding display fields. For the wind
speed a value will not be given (because the minimum value would always be "0").
• Calling up maximum values
Press the MIN/MAX key once again (starting from the normal display press the key twice). MAX
appears in the centre of the display.
The maximum values are indicated in the corresponding display fields.
• Go back to normal display
If you press the MIN/MAX key again, you go back to the normal display, MAX appears in the
display.

Indicating the time/date for the single extreme value

If required, you can indicate the time and date at which each single value was measured.
Proceed as follows:
• First, select either the indication of the minimum values (press the MIN/MAX key once, MIN is
shown in the LC display) or the indication of the maximum values (press the MIN/MAX key twice,
MAX is shown in the LC display).
• Now, the value desired can be displayed by pressing the SENSOR key several times.
Order of indication:
indoor temperature
wind speed (MAX value only)
Each time, only one display field is shown with its extreme value, at the bottom the point
of time and date appear at which the extreme value was measured.
• By a next pressure on the SENSOR key you come back to the overview display of all extreme values
(MIN or MAX, depending on your selection of the minimum or maximum values).
64
indoor air humidity outdoor temperature outdoor air humidity