Brief Instructions - Conrad WS222 Bedienungsanleitung

20. Brief Instructions

Step 1
Install the mast (own mast or sepa-
rately purchased mast) and put on the
multipurpose sensor
(See from Page 51)
Open the battery compartment of the
multipurpose sensor, turn the lower
part to the left and slide it downwards
(See from Page 51)
Step 3
Insert the batteries into the multipur-
pose sensor, close the battery com-
partment
(See Page 53)
Insert the batteries into the base sta-
tion; DO NOT PRESS ANY KEY at the
base station!
(See Page 54)
Step 5
Wait 15 minutes to allow the base sta-
tion to identify the sensor(s)
(See Page 54)
Configure the base station (set the date,
time, etc.)
(See from Page 58)
Step 7
Set up the base station by using a foot
or hanging it on the wall
(See Page 55)
Step 2
Step 4
Step 6
81