Conrad WS222 Bedienungsanleitung Seite 55

• After the synchronisation, the normal display of all weather data is shown.
Only sunrise and sunset as well as the phase of the moon have not been indicated yet,
because time and data are to be set before.
• Configure the base station as described in chapter 9 "Configuration and Operation".
• The base station can either be hung up on the wall (a suited opening is provided on the back side)
or placed on a foot onto a surface.
If you drive a nail into the wall or drill a hole for a plug with screw for this purpose,
pay attention that no power, gas or water pipes can be damaged, grave danger!
• If you want to use the foot, first put the front central spike of the foot into the supports on the back
side of the base station. Then, swing the foot a little bit back till the two rear spikes lock into the
catch supports at the bottom of the base station.
d) Registration of Sensors during Normal Operation
When starting up the product, all available suited sensors are registered at the base station in the
synchronisation mode and then received during normal operation
(time required for the synchronisation of the base station takes about 15 minutes after inserting the
batteries, time required for the synchronisation of the sensors takes about 5 minutes after inserting
the batteries).
To register further new, additionally purchased sensors (or sensors lost during the battery
replacement) you do not need to follow the procedure of the initial start-up.
All data saved (minimum and maximum values, time etc.) would be lost during this kind
of proceeding.
Every day, the base station performs a synchronisation test at 8 a.m. and 6 p.m. so that it can identify
new sensors (or a sensor with battery replacement) automatically.
But if the new sensor is not indicated, the problem may be found in the coverage (see
chapter 12 "Coverage").
55