The Appliance; Before First Use; Initial Cleaning; Initial Use - Gastroback DESIGN ESPRESSO PICCOLO PRO M Bedienungsanleitung

THE APPLIANCE

1
2
3
4
5
6
7
8
9
10
20
1. Cup plate 10. Internal drip tray
2. Pressure gauge 11. Single shot filter
3. "Latte Macchiato" button 12. Double shot filter
4. "Cappuccino" button 13. Milk tank lid
5. "Espresso" button 14. Milk wand knob
6. On/off button 15. Slicone tube
7. Brewing head 16. Milk tank
8. Drip plate 17. Milk tank base
9. Drip tray 18. ESE pod
32
25
11
24
12
23
13
14
22
15
16
21
17
18
19
19. Measuring spoon with tamper
20. Filter holder
21. Milk wand
22. Milk wand connection
23. Milk tank lock
24. Water tank
25. Water tank lid
32

BEFORE FIRST USE

INITIAL CLEANING

• Carefully remove the appliance from the packaging and remove all packaging
materials.
• Remove all accessories from the packaging and from the appliance.
• Remove the water tank.
• Clean the water tank and its lid, the measuring spoon and the filters as well as
the filter holder with warm water and some mild dish-washing liquid. After that,
rinse with clear water and dry with a soft dry cloth.
• Wipe the body of the appliance and the drip tray with drip plate using a soft,
damp cloth and dry all parts with a soft dry cloth.
• Only the milk tank and its lid are dishwasher-safe. Never clean any other part of
the appliance in the dishwasher.

INITIAL USE

1. Assemble all parts of the milk tank. Fill the water tank and the milk tank with cold
water up to the MAX marking.
2. Connect the power plug to an electrical outlet with suitable voltage.
3. Press the on/off button. The operating light lights up and the appliance starts
preheating automatically. Once preheating is finished, all the button indicators
light up continuously. The preheating process takes approx. 2 minutes.
4. Place a cup under the brewing head. Turn the milk wand knob so that the
milk wand points at the cup. Keep the "Latte Macchiato" button pressed for
approx. 3 seconds. The appliance dispenses hot water from the milk wand.
Let it flow out for approx. 8 seconds, then press the "Latte Macchiato" button
again to stop. This process allows the water to flow into the empty pump for
the first use.
NOTE
There will be a loud noise and little shake when the appliance is operating for the
first time. It's normal for a 20bar pump. The noise will be weaker during future usage.
5. Insert a filter into the filter holder.
6. Insert the filter holder without ground coffee into the brewing head with a 45°
movement to the left and turn it to the right to lock it in place. The filter holder
must be perpendicular to the appliance or slightly tilted towards the right.
7. Place an empty cup under the filter holder and press the "Espresso" button to start
the brewing cycle.
8. After the brewing cycle has finished, discard the water.
9. The appliance is now ready to be used.
33