Gastroback DESIGN ESPRESSO PICCOLO PRO M Bedienungsanleitung Seite 22

Problem Possible cause
Coffee is ground too coarsely.
Coffee runs through too Too little coffee in filter.
quickly.
Ground coffee is not tamped
strong enough.
Appliance is not pre-warmed.
Coffee is cold.
Cups are not pre-warmed.
Single shot filter was used for
double shot of espresso.
Coffee is too weak. The amount of ground coffee is
too little.
Ground coffee is too coarse.
The water tank is not installed
correctly.
Water is pooled under
the appliance.
The drip tray is filled with
water.
Too much coffee in the filter.
Ground coffee is sticking to
Coffee is dripping out
the sealing ring of the brewing
of the rim of the filter
head.
holder.
Filter holder is not completely
closed.
The milk tank is not inserted.
The "Cappuccino" button
and "Latte Macchiato"
button indicators do not
The milk tank is not fully
light up.
inserted.
The "Espresso" button,
"Cappuccino" button,
and "Latte Macchiato" Water tank is out of water.
button indicators are
flashing green.
42
Solution
Ensure appropriate degree of grinding.
Ensure appropriate amount.
Tamp ground coffee more strongly.
Let hot water run through the appliance with
the inserted filter holder (with filter but without
ground coffee) before extracting the first coffee
to warm up the brewing system.
Pre-warm cups with warm water.
Use the double shot filter for double shot of
espresso.
Increase the amount of ground coffee.
Use a finer grind.
Remove the water tank and correctly install it.
Empty and clean drip tray.
Make sure to use the correct amount of coffee.
Turn of the appliance, wait until it has cooled
down and then clean the filter, the filter holder
and the brewing head with its sealing ring.
Insert the filter holder and turn the handle to the
right until you feel some resistance.
Insert the milk tank into the appliance, and push
the milk tank lock to the lock position.
If the milk tank is on the appliance, push it in
firmly and push the milk tank lock to the lock
position until "Cappuccino" button and "Latte
Macchiato" button indicators light up.
Refill the water tank with water. Press any of
the three buttons.
Problem Possible cause
Appliance does not have
enough steam.
Milk is not foamy after
frothing or it is not
Milk is not cold enough.
coming out of the milk
wand.
Milk wand is blocked.
The volume of
cappuccino or latte
macchiato that comes Milk tube is blocked.
out is different every
time.
Bad smell comes out of There is some milk residue in
the milk tube. the milk-tank system.
Solution
Make sure there is enough water in the water
tank.
Chill milk and frothing pitcher prior to making
cappuccino or latte macchiato.
Follow the instructions to clean the milk tank
and milk tube.
Follow the instructions to clean the milk tank
and milk tube.
Follow the instructions to clean the milk tank
and milk tube.
43