During Operation - Dräger X-am 5600 Gebrauchsanweisung

2. Observe any warning
The instrument can be operated normally. If the warning message does not
disappear automatically during operation, the instrument must be serviced
after the end of use.
The instrument is not ready to measure and requires maintenance.
3. Check that the gas inlet opening on the instrument is not covered or dirty.
! WARNING
Explosion hazard! To reduce the risk of ignition of a flammable or explosive
atmosphere, strictly adhere to the following warning statements:
In an oxygen enriched atmosphere (>21 vol. % O

cannot be guaranteed; remove instrument from the explosion-hazard area.
High off-scale readings may indicate an explosive concentration.

6.5

During operation

During operation, the measured values for every measured gas are

displayed.
In the event of an alarm, the corresponding displays, the visual, audible and

vibration alarms are activated – see Chapter "Identifying alarms" on
Page 38.
If a measuring range is exceeded or not reached, the following displays are

shown instead of the measured value display:
» « (measuring range exceeded) or
» « (below measuring range) or
After the measuring range of the TOX measuring channels has been

exceeded temporarily (up to one hour), checking the measuring channels is
not necessary.
Special states in which there is no measuring operation (quick menu,
calibration menu, warm-up of sensors, password input) are indicated by a
visual signal (slow flashing of the alarm LED
or fault messages.
Operation
), the explosion protection
2
en
).
37