I) Installing The Impellers On The Wing; J) Installing The Engine Cowlings - Reely R 777 Bedienungsanleitung

i) Installing the impellers on the wing

Attach the impeller (1) from the outside to the attachment blocks (2) already
glued to the wing. Tighten the impellers using two M2 x 15 mm screws (3).
Make sure to secure the screw connection using threadlocker.
Use servo tape to attach the speed controllers (4) into the designated recesses
in the wing (see figure 9).
Install the power cables and the connection cables for the remote control through
the cable duct (5).
Extend the power connecting wires of the speed controller so that a length of
approx. 20 cm protrudes from the surface (also see figures 12 and 17). As a
result, connecting the speed controllers to the batteries later on will be easier.

j) Installing the engine cowlings

Install the engine cowlings (1) so that the small rear cut-outs in the formed
parts (2) point inwards and can be used as cable guides.
The two engine cowling halves can then be secured using transparent adhesive
tape.
26
Illustration 11
Illustration 12
Illustration 13