Installation & removal
NOTICE: Always switch off the power first, before removing the EnergyPak.
Removing the EnergyPak (Key Lock Type):
•
Hold the battery in the frame to make
sure it cannot drop when unlocking;
•
Insert the key and unlock the
EnergyPak. The EnergyPak will be
ejected slightly
•
- For top loading integrated batteries
only: Lift out the EnergyPak to remove.
•
Push the drop protection lever to fully
unlock the EnergyPak;
•
Remove the battery from the bike.
Removing the EnergyPak (Torx Lock
Type):
•
Hold the battery in the frame to make
sure it cannot drop when unlocking;
•
Insert the Torx tool size 25 and turn
counter-clockwise to release the
EnergyPak (the screw is endless so it
will not come out);
•
Push the drop protection lever to fully
unlock the EnergyPak;
•
Remove the battery from the bike.
Installing the EnergyPak
•
Reverse removal procedure to install
the EnergyPak.
•
Make sure the connector slots are
aligned correctly at the bottom;
•
Push the top of the EnergyPak and
make sure the EnergyPak is secured
properly (a 'click' can be noticed while
doing so);
•
Pull out the key.
8 Using your bike