Constant Cutting Speed - Css Function - Optimum OPTiturn TH 4210 Betriebsanleitung

4.24.2 Constant cutting speed - CSS function

INFORMATION
Can only be used in conjunction with speed-controlled lathes.
Press the CSS key to call up the CSS function. Press the

button to confirm the entry according to the prompt.
You will start the CSS function,
Are you sure?
Enter the gear level in which you are working. (You must set the maximum and minimum

speed of each stage in advance).
Enter the gear step you are
working on.
Confirm whether the entered stage and the corresponding speed range are correct.

Press the key
The machine is working on
Gear 1 , 50 -- 800 RPM.
Are you sure?
Entry of the maximum speed of the chuck.

Enter the max speed of the
chuck.
Version 1.0.2 - 2022-05-02
• Addition
• Subtraction
• Multiplication
• Division
Tool data function
to return and press the key
Originalbetriebsanleitung

Calculator function on page 148

Tool Data Function on page 148

Recall of tool data on page 149
button to exit and the
to continue entering.
DPA32 EN
145