Safety; Overview Of The Control Elements - Optimum OPTiturn TH 4210 Betriebsanleitung

4.2

Safety

Commission the lathe only under the following conditions:
The lathe is in proper working order.

The lathe is used as prescribed.

Follow the operating instructions.

All safety devices are installed and activated.

Eliminate or have all malfunctions rectified promptly. Stop the lathe immediately in the event of
any abnormality in operation and make sure it cannot be started-up accidentally or without
authorisation. Notify the person responsible immediately of any modification.

Safety during operation on page 105
4.3

Overview of the control elements

CAUTION!
End stop on lathe saddle.
The mechanical end stop with turret head at the lathe slide must not be dismantled.
ATTENTION!
Damage to couplings, mechanical parts. The automatic feed is not designed to move
onto mechanical stops or the mechanical end of the headstock.
Lockable
main switch
Engaging lever thread
cutting
Pump of
central lubrication
Version 1.0.2 - 2022-05-02
Selection lever
Rotational direction of
feed rod
Engaging lever for
Direction switch for
cross feed / Longitudi-
cross feed
End stop Quadruplicate tool
lathe saddle
Translation of original operating manual
Selection lever feed direction
Shift lever
Rotational direction
nal feed
Tailstock
holder
TH4210 | TH4210D | TH4215D EN
121