Restarting Opso With Visual Indicator; Maintenance; Replacement - GOK VSR 0523 Montage- Und Bedienungsanleitung

Fault cause
Pressure gauge indicates
incorrect values or is not
working at all.

RESTARTING OPSO WITH VISUAL INDICATOR

If the safety overpressure shut-off valve OPSO has responded, which is shown in RED on the
visual indicator - take the following steps.
1. Close the gas withdrawal valve.
2. Vent the pressure regulator  loosen the screw connection on the outlet side
3. Ventilate the inlet pressure  Loosen the connection on the inlet side
4. Tighten all connections again.
5. After elimination of defects, open the gas cylinder valve or the shut-off fittings.
6. Unscrew the protective cap
7. Turn the protective cap
until the spindle
8. Screw the protective cap
is ready to operate  and the display is GREEN.
9. OPSO
10. Check for leaks.

MAINTENANCE

Upon proper ASSEMBLY and OPERATION, the product is maintenance-free.

REPLACEMENT

If there is any sign of wear or if the product or parts thereof are damaged, it must be replaced.
When the product has been replaced, observe the steps ASSEMBLY, LEAK TESTING and
START-UP.
To ensure that the installation works faultlessly under normal operating conditions, it is
recommended that you replace the device within 10 years of the date of manufacture.
Product damaged due to flooding!
This causes corrosion and malfunctions to the pressure regulator.
Replace the pressure regulator following flooding!
28 / 120
Action
Pressure gauge is defective.
 close the gas feed: replace only when the
LPG system is completely de-pressurised.
by hand.
around and pull out the spindle
clicks into place and remains open.
on again by hand.
.
with the release device
Artikel-Nr. 05 239 50 l
.