Starting And Stopping The Machine; Parking Brake - Nilfisk SR 1601 D3 Betriebsanleitung, Originalanleitung

STARTING AND STOPPING THE MACHINE

Starting the machine
NOTE
The driver's seat (32) is equipped with a safety sensor, which allows the machine to be started up and driven only when
the operator is on the driver's seat.
1. (For SR 1601 D3) Turn the ignition key (66) clockwise to "I" and hold it until the pre-heating glow plug indicator (65) turns off.
Do not perform the step above, if the engine is already on and warmed up.
(For SR 1601 LPG3) Open the LPG tank safety valve (50) slowly. Pull the engine choke lever (68).
(For SR 1601 P3) Pull the engine choke lever (68).
2. Turn the ignition key (66) clockwise to "II", then release it when the engine starts.
If the engine does not start after running the starter for 15 seconds, release the ignition key, wait 1 minute and then repeat
steps 1 and 2.
(For SR 1601 LPG3 and SR 1601 P3) After the ignition, let the engine run for a few seconds, then release the choke lever
(68).
3. Before using the machine, run the engine at idle for 5 minutes by turning the engine speed lever (51) backward (idle speed).
4. Disengage the parking brake.
5. Turn the engine speed lever (51) forward (working speed) and drive the machine at slow speed for 2 or 3 minutes to warm up
the hydraulic system.
6. Press the front part of the drive pedal (37) to move forward and the rear part to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal.
WARNING!
When steering, avoid abrupt direction changes, pay careful attention and drive the machine at slow speed,
especially when the hopper is full or when operating on inclines.
Drive the machine slowly on inclines. Use the brake pedal (35) to control machine speed while descending
inclines.
Do not turn the machine on an incline; drive straight up or down.
Stopping the machine
7. To stop the machine, release the pedal (37).
To stop the machine quickly, press also the brake pedal (36).
8. Turn off the machine by turning the ignition key (66) to "0", then remove it.
9. Engage the parking brake.

PARKING BRAKE

1. Engage the parking brake by pressing the pedals (35) and (36) simultaneously.
2. Disengage the parking brake by pressing and releasing the pedal (35).
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope or incline.
Downloaded from www.Manualslib.com manuals search engine
USER MANUAL
33019216 - SR 1601 D3 / LPG3 / P3
ENGLISH
19