Stopping The Machine - Nilfisk SCRUBTEC 344 Bedienungshandbuch

10. Adjust the detergent flow by pressing the push-button (43) as necessary, depending on the type of cleaning to be performed.
When the LED is on, it indicates the value in litres per minute of solution flow supplied, as shown in the Figure 3. When the
LEDs are off, the solution flow is stopped.
11. If necessary, deactivate the vacuum system by pressing the push-button (44, LED off), then press it again to reactivate it (LED
on).
12. If necessary, stop the machine and turn the forward speed adjusting handwheel (32) as shown below:
• Turn it counter-clockwise to increase the forward speed;
• Turn it clockwise to decrease the forward speed.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Nilfisk suggests to go near the walls with the right side of
the machine as shown in figure 4.
CAUTION!
To avoid any damage to the floor surface, turn off the brush when the machine stops in one place.

STOPPING THE MACHINE

1. Stop the machine with the handlebar (1).
2. Lift the brush deck by pressing the pedal (9-A).
3. Lift the squeegee (26) with the lever (7).
4. Press the push-button (42, LED off) to stop the machine functions.
5. Turn the switch (41) to "0".
6. Disconnect the power supply cable plug (4) from the electrical mains and place it on the holder (5).
09/2017
INSTRUCTIONS FOR USE
0.3 0.7 2.0 l/min
Figure 3
Figure 4
9100002292 - SC401, SCRUBTEC 344
P100952
ENGLISH
P100953
13