Resetting To Factory Settings - Endress+Hauser CLM280 Betriebsanleitung

Commissioning
– Tref 25 (reference temperature 25 °C (77 °F))
4. Press <RUN/ENTER>.
5. Press <CAL> to select the measured value display.
You can choose from:
– Conductivity (S/cm)
– Resistivity (MΩ
6. Press <RUN/ENTER>.

12.7 Resetting to factory settings

1. Press <RUN/ENTER> and <CAL> simultaneously.
2. Press <RUN/ENTER> again.
All the settings are reset to the factory settings and the instrument switches to the measur-
ing mode.
The following factory settings exist:
Parameter
Measuring mode
Cell constant
Temperature compensation
Reference temperature
!
Note!
Always perform a reset after replacing the batteries.
26
.
cm)
Value
-1
0.475 cm
Nonlinear (nLF)
25 °C (77 °F)
CLM280
Endress+Hauser