Commissioning; Function Check; Display And Operating Elements - Endress+Hauser CLM280 Betriebsanleitung

Commissioning

12 Commissioning

12.1 Function check

Before initial commissioning, make sure that:
• the sensor is correctly connected
• the batteries are sufficiently charged

12.2 Display and operating elements

1
5
Fig. 8: LC display
CAL
Abb. 9: Key field
22
2
4
M
I
AR
RUN/ENTER
3
1 Measured value
2 Status display indicator
3 Sensor symbol
4 Temperature
5 Function indicators
Function indicators
LoBat Low battery
TP Symbol indicating the temperature
Tref25 Reference temperature at 25 °C (77 °F)
Tref20 Reference temperature at 20 °C (68 °F)
nLF Nonlinear temperature compensation
Cal Calibration function
ARng Autorange function switched on
AR Autoread function switched on
a0008486
M Select the operating mode
I
Switch on/off
CAL Calibration
AR Autoread on/off (Hold function)
RUN/
ENTER Start/accept
a0008490
CLM280
Endress+Hauser