Persons Authorized To Perform Alterations - Endress+Hauser Promag 300 Installationsanleitung

Order structure
DK6009-
DK6011-
Switching of I/O and upgrading of I/O hardware
DKZ004–
2

Persons authorized to perform alterations

Authorization to perform alterations is dependent on the approval of the measuring device.
The table below shows the authorized group of people in each case.
2.1 Activating application packages / switching the I/O function:
Measuring device approval
Without approval
With approval (e.g. IECEx)
For custody transfer
1) 1 = Qualified specialist on customer side, 2 = Service technician authorized by Endress+Hauser,
3 = Endress+Hauser (return measuring device to manufacturer)
4 = Check with local approval center if installation/alteration or conversion must be performed under supervision.
Endress+Hauser
Procedure
For the subsequent activation of additional
application packages with a license code
specifically linked to the device serial number
for t-mass 300
For the subsequent activation of additional
application packages with a license code
specifically linked to the device serial number
for t-mass 500-digital
Switching of I/O for Promag, Promass,
Prosonic Flow 300, 500, 500-digital,
t-mass 300, 500-digital, Prosonic Flow 400
Upgrading of I/O Hardware for Promag,
Promass, Prosonic Flow 300, 500, 500-
digital, t-mass 300, 500-digital, Prosonic
Flow 400
Contents
License code, wired-on tag plate with new
order code and associated device serial
number, wire cable with crimp sleeve,
mounting bracket, nameplate (front foil,
optional), Installation Instructions
License code, wired-on tag plate with new
order code and associated device serial
number, wire cable with crimp sleeve,
mounting bracket, nameplate (front foil,
optional), Installation Instructions
License code, wired-on tag plate with new
order code and associated device serial
number, wire cable with crimp sleeve,
mounting bracket, nameplate (front foil,
optional), Installation Instructions
I/O hardware, license code (apart from
relays), wired-on tag plate with new order
code and associated device serial number,
wire cable with crimp sleeve, mounting
bracket, nameplate (front foil, optional),
Installation Instructions
Personnel authorized to carry out alterations
1, 2, 3
1, 2, 3
4
EA01164D
1)
5