WIKA CPH6200 Betriebsanleitung Seite 30

6. Commissioning, operation
6.5.2.1 Starting logger recording
1. Press the [STORE/QUIT] button for 2 seconds.
⇒
The display shows "Lo66 rvn":
2. Press the [STORE/QUIT] button once more.
EN
⇒
Recording starts.
With each recording, the display will briefly show "St.XXXX". Here, XXXX is the number of
the data set 1 ... 4,000 or 1 ... 10,000.
The following displays may appear for logger recording:
Lo66
rvn
Lo66
CLr
Lo66
FvLL
Lo.Po = on
6.5.2.2 Stopping the logger recording
1. Press the [STORE/QUIT] button briefly.
⇒
A confirmation prompt then appears:
2. With the [▼/MIN] or [▲/MAX] button, select the desired function.
The following functions can be selected:
SToP yes
SToP no
3. With the [STORE/QUIT] button, confirm the selection.
4. Press the [SET/MENU] button.
⇒
Return to main menu.
If, during a cyclic data logging, the measuring instrument is switched off, you
will automatically be asked whether the data logging should be stopped. The
instrument can only be switched off after the recording has been stopped.
The auto power-off function is deactivated during recording!
30
Displayed when logger recording is to be started.
Function "Delete" will be selected
Shows in the event the logger memory is full. The recording will be
stopped automatically.
Appears with the low-power logger function.
As soon as the logger memory is full, the instrument switches itself
off.
Stop recording.
Do not stop recording (cancel the process).
WIKA operating instructions, model CPH6200