Alarm (Al.); Real-Time Clock (Cloc) - WIKA CPH6200 Betriebsanleitung

6. Commissioning, operation
6.4.10

Alarm (AL.)

There are 3 possible settings: off = "AL.oFF", on = "AL.on", or on = "AL.no.So".
Under the following conditions, an alarm is given when the alarm function "AL.on" or "AL.
no.So" is active:
EN
Value is below lower alarm limit "AL.Lo" or above upper alarm limit "AL.Hi".
■
Sensor error (Sens Erro)
■
Low battery, 'At'
■
Err.7: System error
■
In the event of an alarm, the display flashes and the instrument beeps. If the serial
interface is used, the 'PRIO' flag is used.
6.4.11

Real-time clock (CLOC)

The real-time clock is needed for the time allocation of the logger data. If required, check
the settings.
Checking the real-time clock
1. Press the [SET/MENU] button for 2 seconds.
⇒
The main menu "SEt" is accessed.
2. Keep pressing the [SET/MENU] button until "SEt CLOC" is displayed.
3. With the [▶/TARA] button, select the "CLOC" parameters.
4. With the [▼/MIN] or [▲/MAX] buttons, enter the time.
5. With the [▶/TARA] button, select the "YEAr" parameters.
6. With the [▼/MIN] or [▲/MAX] buttons, enter the year.
7. With the [▶/TARA] button, select the "dAtE" parameters.
8. With the [▼/MIN] or [▲/MAX] buttons, enter the day and month.
9. With the [STORE/QUIT] button, confirm the entry.
10. Press the [SET/MENU] button.
⇒
Return to main menu.
After changing the battery, the menu for setting the clock is automatically started after
switching on the instrument.
26 WIKA operating instructions, model CPH6200