WIKA CPH6200 Betriebsanleitung Seite 28

6. Commissioning, operation
1)
Sensor 2 : Min. peak, max. peak since last data point
■
Difference (sensor 1 - sensor 2)
■
Difference (sensor 1 - sensor 2)
■
Time and date stamp at that data point
■
EN
With each recording, "St.XX" will be displayed briefly. XX represents the number of the
measuring result.
6.5.1.1 Delete stored data
1. Press the [STORE/QUIT] button for 2 seconds.
⇒
The main menu "CLr." is accessed.
2. With the [▼/MIN] or [▲/MAX] button, select the desired function.
The following functions for deleting can be selected:
.
CLr no
.
CLr ALL
.
CLr LASt
3. With the [STORE/QUIT] button, confirm the selection.
4. Press the [SET/MENU] button.
⇒
Return to main menu.
Logger memory is full
Lo66
FvLL
6.5.1.2 Reviewing individual values
In contrast to the cyclic logger function, individual values can also be viewed directly in
the display:
1. Press the [SET/MENU] button for 2 seconds.
⇒
Menu item "rEAd Lo66" will be accessed.
2. With the [▶/TARA] button, the last measuring result is displayed.
3. Press the [▶/TARA] button again.
⇒
Individual values of the measuring result are displayed.
4. With the [▼/MIN] or [▲/MAX] buttons, recall another measuring result.
5. Press the [▶/TARA] button.
⇒
Individual values of the new measuring result are displayed.
1) Only valid for 2-channel version CPH6200-S2
28
1)
: Measured value at that data point
1)
: Min. peak, Max. peak since last data point
Do not delete (cancel the process).
Delete all data sets.
Clear the last data set.
Shows in the event the logger memory is full. The recording will be
stopped automatically.
WIKA operating instructions, model CPH6200