Resetting The Default Settings - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

Configuration

Resetting the default settings

This function is used to reset the default settings of the KVM extender. By perform-
ing this function, the default settings mentioned on page 69 are reactivated.
How to reset the default settings:
NOTE: Open the local OSD of the console module by pressing the
(default: Alt + Num ) if you want to reset the
instead of the settings of the extender system.
1. Open the remote OSD of the computer module by pressing
(default:
Ctrl
Open the local OSD of the console module by pressing the
(default: Alt +
ule.
2. Select the row
(local OSD) and press
3. Select the row
4. Confirm the security prompt or cancel the process.
89 · G&D VisionXS-IP-F-DP-UHR
+ ) if you want to reset the settings of the extender system.
Num
Num ) if you want to reset the local settings of the console mod-
System setup (remote OSD) or
Enter .
Set system defaults
local settings of the console module only
Console utility
and press Enter .
local hotkey
remote hotkey
local hotkey