Configuring A Kvm-Over-Ip Connection - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

3. Select the entry Network setup
4. Select the entry Interfaces
5. Enter the following data under
Global
Press
preferences:
 Static:
 DHCP:
Hostname:
Enter the device hostname.
Domain: Enter the domain the device is to belong to.
Gateway:
Enter the gateway IP address.
DNS Server 1: Enter the IP address of the DNS server.
DNS Server 2: Optionally, enter the IP address of another DNS server.
6. Press to save your settings.
F2

Configuring a KVM-over-IP connection

The of the console module (host) as well as the
IP address
module must be specified to establish a
puter module.
The configuration of both the
exchanged between the two modules.
NOTE:
The configuration of both the
automatically exchanged between the two modules.
How to configure the ports of the KVM-over-IP connection:
1. Use the local hotkey
2. Press F11 to open the Configuration menu.
3. Select the entry KVM Connection
IMPORTANT: In order to protect the configuration of the KVM-over-IP connection
from unwanted access, we recommend to activate the password protection.
Select the Password protection
4. Enter the following data under
Control Port:
Communication Port:
Data Port:
5. Press to save your settings.
F2
Establishing a KVM-over-IP™ connection for the first time
and press Enter
and press Enter .
Main Network
F8 to select the global preferences:
uses static settings.
obtains settings from a DHCP server.
KVM-over-IP
communication ports
communication ports
Alt + Num to open the OSD of the console module.
and press Enter
entry, press F8
:
Local
Enter the number of the port you want to use.
Enter the number of the port you want to use.
Enter the number of the port you want to use.
.
:
of the computer
control port
connection through the com-
and the data ports are automatically
and the
.
( on ) and then F2 to save your settings.
G&D VisionXS-IP-F-DP-UHR · 32
data ports are