G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung Seite 137

Establishing a connection to the Gigabit Ethernet
Transmission 1 Transmission 2 Transmission 2 Service Service
IMPORTANT:
The device uses components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE: Remove the protection caps from the Transmission interfaces and the cable
plugs.
Insert the LC plug of a fibre optic cable, which is available as
Transmission 1|Tx:
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
Insert the LC plug of a fibre optic cable, which is available as
Transmission 1|Rx:
accessory, into this interface. Connect the other end to the Gigabit Ethernet.
NOTE: The activation of the
interface.
To use the
Transmission 2
Choose the right SFP transceiver
The Transm. Redundancy options
Transm. Redundancy feature
Use this interface to establish a redundant transmission connection (link aggregation)
with the Gigabit network.
Network Network Pwr Main Power Pwr Main Power
Transm. Redundancy
interface, you need an additional SFP transceiver.
for your variant of the
contain both, a corresponding
.
Red. Power Red. Power
feature activates the
VisionXS-IP-F-DP-UHR
SFP transceiver
G&D VisionXS-IP-F-DP-UHR · 16
Installation
Transmission 2
series.
and the