Selecting The Edid Mode Of The Kvm Extender - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

Selecting the EDID mode of the KVM extender

EDID information (Extended Display Identification Data) of a monitor informs the gra-
phics card of a connected computer about different technical device features. The
information is usually transmitted via Enhanced-DDC (Enhanced Display Data Chan-
nel) and without any alteration between KVM extender and computer.
NOTE:
For initial operation and when connecting another monitor, please follow
the activation sequence recommended on page 18.
Special GUD profiles are available for some resolutions. The names of these profiles
contain information about the preferred resolution that is sent to the computer's
video card when the profile is used.
As an alternative, you can use the web application
read the EDID profile of a monitor. The KVM extender will then transmit it to the
connected computer. For detailed information on this topic, refer to the separate
manual of the
Config Panel
How to select the EDID mode of KVM extenders:
1. Press Ctrl+Num
2. Select the row
3. Under
EDID mode
 automatic treatment of EDID data (default)
auto
user  use of a G&D profile or a profile that has been read out via
web application
4. If the option user
Use the
arrow keys
Save your selection by pressing
5. Press F2 to save your settings.
web application.
(default) to open the OSD.
Target setup and press Enter
press to select one of the following options:
F8
has been selected, select the row
to select the profile you want the activate and press
F2 .
Config Panel web application to
.
Assign EDID and press
G&D VisionXS-IP-F-DP-UHR · 78
Configuration
Enter .
.
F8