The Visionxs-Ip-F-Dp-Uhr Series; Use As Extender Or Matrix Switch Modules - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

The VisionXS-IP-F-DP-UHR series

The VisionXS-IP-F-DP-UHR series
KVM extenders of the
a console module.
Connect the computer to be operated to the computer module (
remote console is connected to the console module (
Both the computer module and the console module are connected using two optical
fibres.
NOTE:
You can also use a cable to establish a direct connection between computer
module and console module.
Signals of keyboard, mouse and DisplayPort™ video of the computer connected are
transmitted using these fibres and enable you to operate the computer remotely.

Use as extender or matrix switch modules

You can use the modules as either extender or matrix switch modules:
 Extender modules:
and the console module. The configured connection between the modules is
restored each time the modules are restarted.
ADVICE: Use the
IP-MUX
available in the OSD via separate computer modules.
 Matrix switch modules:
ControlCenter-IP-XS , you can use the modules as end devices of the matrix switch.
In this case, configure a KVM-over-IP connection to the IP matrix switch for the
modules.
In this configuration, the IP matrix switch enables the flexible connection of a con-
sole module to a computer module.
5 · G&D VisionXS-IP-F-DP-UHR
VisionXS-IP-F-DP-UHR
Configure a KVM-over-IP connection between the computer
functionality (see page 39 ff.) to make up to 20 computers
In combination with the IP matrix switch
series consist of a computer module and
VisionXS-IP-CON
). The
VisionXS-IP-CPU
).
ControlCenter-IP or