Web Application Config Panel; Basic Operation Of The Web Application; Starting The Web Application; Selecting The Language Of The Web Application - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

Web application Config Panel

The Config Panel web application provides a graphical user interface to configure and
monitor the KVM extender.

Basic operation of the web application

The web application can be used in the entire network independently from the loca-
tions of the devices and consoles connected to the KVM system.
NOTE: The separate manual provides information about system requirements, the
required configuration of the network interfaces at the
devices and the operation of the web application.

Starting the web application

Config Panel
How to start the
1. Enter the following URL in the address bar:
https://[IP address of the user or computer module]
2. Enter the following data in the login mask:
Username:
Password:
IMPORTANT:
Change the administrator account's default password.
The default access data is:
Admin
 Username:
 Password: see login information on the label on the bottom of the device
3. Click on .
Login

Selecting the language of the web application

NOTE: The selected language is saved in the user settings of the active user. The
next time this user logs on, the previously selected language setting is applied.
How to change the language of the web application:
1. Click the language identifier of the current language in the upper right
corner.
2. Switch the language to be used by clicking on the desired language.
web application:
Enter a username.
Enter a password for your user account.
Web application Config Panel
VisionXS-IP-F-DP-UHR
G&D VisionXS-IP-F-DP-UHR · 52