Freeze Mode - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

Freeze mode

If the cable between the computer module and the console module is disconnected
during operation, the KVM extender will not display an image on the remote con-
sole.
Enable the Freeze mode if you want the last image that has been displayed at the con-
sole module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a
connection has been interrupted.
How to configure the Freeze mode:
1. Press
Ctrl+Num
2. Select the row
3. Under Freeze mode
off  Freeze mode is disabled (default)
 Freeze mode is enabled
on
4. If the Freeze mode is active, press
under Freeze visualization
frame  shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
OSD
 shows a coloured frame (
frame+OSD
5. Press F2 to save your settings.
Frozen
(default) to open the OSD.
and press
Console setup
press F8 to select one of the following options:
to select one of the options available
F8
:
popup and the time passed since the
.
Enter
) and Frozen (
frame OSD
G&D VisionXS-IP-F-DP-UHR · 80
Configuration
)