Resetting The Default Settings - G&D VisionXS-IP-C-DP-HR Installation Und Bedienung

Resetting the default settings

This function is used to reset the default settings of the KVM extender. By perform-
ing this function, the default settings mentioned on page 68 are reactivated.
How to reset the default settings:
NOTE: Open the local OSD of the console module by pressing the
(default: Alt + Num ) if you want to reset the
instead of the settings of the extender system.
1. Open the remote OSD of the computer module by pressing
(default: Ctrl + Num
Open the local OSD of the console module by pressing the
(default: Alt + Num
ule.
2. Select the row
(local OSD) and press
3. Select the row
4. Confirm the security prompt or cancel the process.
local
) if you want to reset the settings of the extender system.
) if you want to reset the local settings of the console mod-
(remote OSD) or
System setup
Enter .
Set system defaults and press
settings of the console module only
remote hotkey
local hotkey
Console utility
Enter .
G&D VisionXS-IP-C-DP-HR · 88
Configuration
local hotkey