Configuration
Selecting the EDID mode of the KVM extender
EDID information (Extended Display Identification Data) of a monitor informs the gra-
phics card of a connected computer about different technical device features. The
information is usually transmitted via Enhanced-DDC (Enhanced Display Data Chan-
nel) and without any alteration between KVM extender and computer.
NOTE:
For initial operation and when connecting another monitor, please follow
the activation sequence recommended on page 17.
Special GUD profiles are available for some resolutions. The names of these profiles
contain information about the preferred resolution that is sent to the computer's
video card when the profile is used.
As an alternative, you can use the web application
read the EDID profile of a monitor. The KVM extender will then transmit it to the
connected computer. For detailed information on this topic, refer to the separate
manual of the
Config Panel
How to select the EDID mode of KVM extenders:
1. Press
Ctrl+Num
2. Select the row
3. Under
EDID mode
automatic treatment of EDID data (default)
auto
use of a G&D profile or a profile that has been read out via
user
web application
4. If the option
Use the
arrow keys
Save your selection by pressing
5. Press
to save your settings.
F2
77 · G&D VisionXS-IP-C-DP-UHR
web application.
(default) to open the OSD.
Target setup
and press
press
to select one of the following options:
F8
user
has been selected, select the row
to select the profile you want the activate and press
Config Panel
Enter
.
Assign EDID
F2
.
web application to
and press
Enter
.
F8
.