Oxford HOTGRIPS PRO Bedienungsanleitung Seite 6

K: TECHNICAL DATA:
• This switch is extremely efficient and will draw zero Amps. Therefore long term
connection will not flatten a battery.
• This switch has been lab-tested to ensure EMC compliance and more importantly
has been subjected to the most severe automotive spike and pulse laboratory
testing to ensure that none of the electrical circuits on the motorcycle could
damage or interfere with the operation of the switch.
• Conforms to relevant European EMC directives.
• 12 Volt systems only (typically running voltage between 13.6 and 14.6volts).
• Current drain: Average 3.6 Amps per pair (50 Watts@14.0V).
• Fuse: 5 Amp mini-blade fuse.
• On some motorcycles that have older or small capacity batteries, the extra
electrical current demanded by the HotGrips® can reduce the battery voltage
levels and replacing this by charging is recommended. Therefore, we always
advise you to connect the battery to a charging system such as one of the Oxford
Oximiser chargers when the bike is not in use.
REV.150922 Page 6 of 94