Oxford HOTGRIPS PRO Bedienungsanleitung Seite 3

H: WIRING HARNESS INSTALLATION:
1. Before removing the grips for the final fitting procedure, it is important to connect
the electrical wiring harness to the battery and the grips. With the motorcycle
engine running the grips can be switched on to make sure that the grips operate as
expected.
2. The loom is designed for ease of fitting. All connections are through the multi-pin
water-proof connectors and cannot be fitted the wrong way around.
3. We recommend that the wiring loom is positioned away from the existing wiring
looms on the motorcycle to avoid any possible electrical interference issues.
4. Both the negative and positive battery connections are fitted with a ring terminal.
This will allow them to be bolted to the battery terminals. It is both preferable and
also the easiest option to connect the positive (+ Red Wire) straight to the positive
(+) battery terminal so that the switch receives sufficient voltage from the vehicles
charging system.
5. The negative or earth (black wire) should be connected to the negative (-) battery
terminal.
6. Direct connection to the battery will not flatten the battery because the switch
uses zero power in standby.
7. If the switch is connected to a switched ignition supply feed, please ensure that the
wiring harness is connected to the main ignition cabling which can take the extra
load of up to 4 amps. Do not remove the fuse from the circuit. It is there to give
protection.
8. Problems are commonly found to be caused when connections are made to the
horn or any lighting circuit.
If unsure, please contact your local Oxford dealer for advice before fitting these
HotGrips®.
650mm
Over-moulded
split ter
50mm
700mm
I: FINAL FITTING OF THE HOTGRIPS®:
1. Use the Superglue provided. It has been proven for the application and we cannot
guarantee the suitability of an alternative. Under no circumstances should the grip
be fitted to the handlebar without glue!
2. WARNING: The Superglue will bond skin and eyes in seconds. Keep out of reach of
children.
• It is very important to fit the grips immediately and without delay because the
superglue provided will bond the HotGrips® to the bars and throttle tube very
quickly.
• Do not let the glue drip onto the paintwork. Shield paintwork appropriately.
3. Clutch (left) HotGrip:
• Apply the glue into the HotGrip and allow it to run down the internal faces of the
HotGrip so that as much of the internal faces are covered with glue as possible.
• Push the grips into place ensuring that the HotGrips® are positioned correctly so
it does not foul the clutch operation.
REV.150922
Weatherproof
connectors
1200mm
5 amp fuse
Bat ter y connector
or switch live
200mm
Page 3 of 94