Troubleshooting - Reely Adventure Bedienungsanleitung

16 Troubleshooting

The model does not respond or responds incorrectly
In the case of 2.4 GHz remote controls, the receiver must be connected to the transmitter. This process is known
as "binding" or "pairing". "Pairing" takes place automatically each time you switch on the transmitter and then the
vehicle.
Release the throttle/brake lever and the steering wheel on the transmitter. Only then you can turn on the vehicle.
Is the vehicle drive battery or the transmitter batteries/rechargeable batteries empty? If so, replace the drive bat-
tery or transmitter batteries/rechargeable batteries.
Is the drive battery correctly connected to the vehicle? Check the connection to see if it is dirty or oxidised.
Is the vehicle too far away? With a fully charged drive battery and batteries/rechargeable batteries in the transmit-
ter, a 50-metre range should be possible. However, it can be reduced by outside influences, such as interference
on the radio frequency or the proximity of other transmitters (not only remote control transmitters but also Wi-Fi/
Bluetooth devices that also use a transmission frequency of 2.4 GHz), metal parts, buildings, etc.
®
The vehicle travels slowly or the steering servo does not respond properly to remote control commands; the
range between the transmitter and the vehicle is very short
The drive battery is nearly empty.
The receiver and the steering servo are powered by the BEC of the integrated speed controller. As a result, the
receiver will not function properly when the drive battery is nearly empty. Replace the drive battery with a fully
charged drive battery (before changing the battery, wait for at least 5–10 minutes for the motor and speed control-
ler to cool down).
Check the batteries/rechargeable batteries in the transmitter.
The vehicle doesn't stop when the throttle/brake lever is released
Use the "TH.TRIM" trim control on the transmitter to correct the trim for the driving function (set to neutral position).
The vehicle does not travel in a straight line
Adjust the tracking on the transmitter with the "ST.TRIM" trim control on the transmitter.
Check the steering linkage, the servo arm and the screw connection.
Did the vehicle have an accident? If so, check the vehicle for any defective or broken parts and replace them if
necessary.
The vehicle doesn't move
The drive battery is empty; the undervoltage detection function has powered off the motor to protect the drive
battery from detrimental deep discharge.
The vehicle is too far away from the transmitter and can no longer recognise a valid radio signal.
The vehicle moves in the opposite direction to the rotary control on the transmitter
Enable the reverse setting for the steering function on the transmitter with the "ST" switch.
38