Charging The Drive Battery - Reely Adventure Bedienungsanleitung

10 Charging the drive battery

The drive battery is empty when the product is shipped and must be charged. Several complete discharge
and charge cycles are required to ensure that the drive battery reaches its maximum performance.
The drive battery is charged using the supplied USB charger.
Attention!
Do not connect the USB cable to the USB port of a computer/laptop or USB hub because their current is
not high enough for charging.
Use, for example, a commercially available USB power adaptor that provides an output current of at least
2 A.
Only use the included USB charger to charge the Li-ion drive battery as the USB charger is a perfect match
for the Li-ion drive battery.
Never recharge the drive battery unattended.
Insert the drive battery for charging on a fixed base, e.g. a flagstone.
Proceed as follows:
Disconnect the drive battery from the vehicle, completely disconnect the plug. Then remove the drive battery from
the vehicle.
The drive battery has two different connections:
– 2-pin T-shaped connector (used for vehicle power supply)
– small 3-pin connector (for charging)
Connect the 3-pin plug of the drive battery to the matching socket on the charging cable of the USB charger. Do
not use force when doing this; the plug is protected against polarity reversal.
Connect the USB charger to a suitable USB power adaptor (output 5 V/DC, min. 2 A); then plug it into a mains
socket. A red LED lights up on the USB charger. A flashing green LED indicates the charging process.
It takes approx. 3 hours to charge an empty battery. When charging is complete, the green LED lights up continu-
ously and the red LED goes out. Disconnect the Li-ion drive battery from the USB charger and the USB charger
from the power supply.
29