Troubleshooting - Reely Black Mono X V2 Bedienungsanleitung

16. Troubleshooting

This model and the remote control were built using the latest technology. However, faults and malfunction may still
occur. The following section shows you how to troubleshoot potential problems.
Problem
The transmitter does not respond and
the power LED is off
The power LED on the transmitter
flashes.
The model does not respond to the
remote control.
Motor is not running
Travel time is too short
Model does not travel straight
Turning circle is too large or rudder
deflection is too small
Strong vibrations
The model boat travels in the direction
opposite to the movement of the rotary
wheel on the transmitter
Motor continues to run in the neutral
position of the throttle trigger switch on
the transmitter
Model boat stops while driving
Solution
• Replace the batteries in the transmitter.
• Check the polarity of the batteries in the transmitter.
• Turn the transmitter on.
• Replace the batteries in the transmitter.
• Execute the pairing function (section 12).
• Check the drive battery and connectors.
• Repeat the power on procedure.
• Check the drive battery charge status.
• Execute the pairing function (section 12).
• Fully charge the drive battery.
• Check the charger for functionality.
• Replace the drive battery.
• Adjust steering trim on the transmitter.
• Correct the end position of the servo/rudder deflection to the left and
right, as described in section 10. i).
• Check the propeller and replace if necessary.
• Grease the drive shaft.
• Set the reverse switch for steering function on the transmitter differ-
ently.
• Set the drive's neutral position with the trim buttons for drive function.
• The undervoltage detection has been activated; see section 11. b).
53