10.11.2.2 Level sensor
The level sensor is located in the side of the casing of the feed dispenser (item 70662).
Operating the level sensor requires no configuration.
When the control unit is restarted (after interruption to power supply), the level sensor
is recognised automatically. The sensor permanently measures the level of feed in
the feed reservoir and, through the message "Food empty", informs you in good time
when the level is low.
The message is displayed on the control unit until:
• The food is replenished or
• The message is acknowledged using the
Please note that after acknowledgement using the
disabled for a number of hours.
10.11.3 Potential errors and their correction
The "Food fault" error appears on the display:
The motor has become blocked, possibly by a foreign body or similar Clear the feed
dispenser. Remove any foreign bodies. Acknowledge the fault using the
and check functioning several times by pressing the feed button
INFO: The installation instructions
for the SmartCoop modules
are available for download at:
www.kerbl-smartcoop.com
CE-conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions
complies with the fundamental requirements and other relevant stipulations and regulati-
ons. The CE mark confirms compliance with the Directives of the European Union.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please con-
sult the valid national regulations. The device must not be disposed of in household waste.
In accordance with the stipulations of the EU Directive on the Disposal of Electrical and
Electronic Devices, the device can be disposed of free of charge at the local waste collection
or recycling centre. Alternatively, it can be returned to retailers who offer a collection service.
The proper disposal helps to ensure environmental protection and prevents any adverse
effects on human health and the environment.
button
button, feed recognition is
button,
briefly.
50