Cleaning Machine; Electric Motor And Wheels; Upper Handlebar Me; Checking Blade Wear - Viking ME 339 C Gebrauchsanleitung

12.2 Cleaning machine

Maintenance interval:
After each use
Care of the machine will protect it against
damage and extend its service life.
● Detach grass catcher box (
Risk of injury!
Before tipping up the mower, place
it on firm, level and flat ground. The
machine may tip over when working
on it in the cleaning position.
Always stand to the side of the
machine. Never work in front of or
behind the mower.
Cleaning position ME 339 C:
● Stand to the right of the machine to tilt it
upwards.
● Set the upper handlebar to the lowest
position (as far as the stop, the detent
lever does not engage in this position).
( 8.1)
● Open ejection flap (1) with the right
hand and hold it open.
● Hold the console with the left hand as
shown and hold the ejection flap open.
Press detent lever (2) with the thumb at
the same time and hold.
● Hold the machine with the right hand at
the front handle and tilt it slowly
rearwards until the handlebar is in
contact with the ground as shown.
● Release ejection flap (1) and detent
lever (2) and check that the machine is
standing securely.
Cleaning position ME 339:
● Fold down dual handlebar (
0478 121 9918 B - EN
● Tilt lawn mower upwards and set down
on lower handlebars (3).
16 Notes on cleaning:
● Clean off dirt using little water, with a
brush or with a cloth. In particular, also
clean the mowing blade. Never spray
water onto motor components, seals,
8.4)
bearing points or electrical parts such
as switches.
● First, remove accumulated clipping
deposits using a stick.
● Remove dirt from the cooling air guide
(inlet slots) between the motor hood
and the lower housing to ensure that
the motor is adequately cooled.
● If necessary, use a special cleaner
(e.g. STIHL special cleaner).

12.3 Electric motor and wheels

The electric motor is maintenance-free.
The wheel bearings are maintenance-free.

12.4 Upper handlebar ME 339

Maintenance interval:
Before each use
The upper handlebar is coated with a
insulating layer. Should this layer become
damaged, the upper handlebar must be
replaced.
8.2)

12.5 Checking blade wear

Maintenance interval:
Before each use
Risk of injury!
Blades are subjected to differing
degrees of wear depending on the
location and duration of use. If you
use the machine on sandy ground
or use it frequently under dry
conditions, the blade will be
subjected to greater loads and will
wear more quickly than the
average. A worn blade may break
off and cause serious injuries. The
instructions for blade maintenance
must therefore always be observed.
● Tilt mower upwards into cleaning
position ( 12.2).
● Clean mowing blade (1).
● Use a slide calliper (2) to measure
blade thickness at 5 points at least. In
particular, minimum thickness must
also be ensured in the area of the blade
wings.
● Place a ruler (3) against the front blade
edge and measure permissible
grinding.
Wear limits:
Blade thickness: > 1,6 mm
Permissible grinding: < 5 mm
The blade must be replaced,
– if it is damaged (notches, cracks),
– if the measured values are achieved at
one or more points or are outside the
permissible limits.
17
41