Residual Heat Display; Using The Timer Function/ Cooking Time Limit - hanseatic MC-IF6417B1-A Gebrauchsanleitung

Residual heat display

During cooking, the heat from the pot is trans-
ferred to the glass ceramic surface of the
cooking zone and the cooking zone becomes
hot. When you switch the appliance off, the
residual heat symbol " " " in the heat setting H
display will begin to flash.
H H
A few seconds later, the appliance will shut off
entirely. All indicators will go out. The residual
H
heat symbol " " " will continue to flash only for
recently used cooking zones.
H H
If the temperature of the cooking zones falls
below a specific value, the residual heat sym-
H
bol " " " will go out.
Using the timer function/
cooking time limit
You can use the timer function as a timer
or use it to set automatic shut-off time for a
cooking zone.
Use as a timer
1. Ensure that the appliance is switched on.
2. Press the timer sensor (7) to set the timer.
3. Press the "+" sensor (10) and "-" sensor
(11) at the same time.
00
The " " " indicator beside the timer sensor will
blink.
Cooking zones and sensors
4. Press the "+" sensor or the "-" sensor to
set the desired number of minutes.
The countdown will start shortly after the
last time the sensor was pressed. The re-
maining time will be shown in the display
and will blink for 5 seconds.
When the time is up, you will hear a sig-
nal tone for 30 seconds. The "
will appear in the display beside the timer
symbol.
Every touch of the "+" sensor or the "-"
sensor increases or reduces the time
in minute intervals.
A longer touch of the "+" sensor or "-" sen-
sor changes the time setting by 10 minute
intervals.
Changing / cancelling the countdown
You can change or cancel the countdown of
the timer at any time.
1. Press the timer sensor (7) to select the
timer.
The remaining number of minutes until
shut-down will flash for a few seconds. The
setting can be changed while this indica-
tor is flashing. Afterwards, the indicator will
again be lit normally.
2. Adjust the minutes using the "+" sensor
(10) and the "-" sensor (11) or set the indi-
0
cator to " " " to switch off the timer.
Page EN-17
00 00
--
" indicator