Change The Time In The Cooking Time Limit - hanseatic MC-IF6417B1-A Gebrauchsanleitung

Page EN-18 Cooking zones and sensors
Use as a cooking time limit
1. The cooking zone that is to be switched
off using the shut-down timer must be in
use.
2. Press the sensor of this cooking zone to
activate the zone.
The heat setting display for the selected
cooking zone will blink.
3. Press the timer sensor (7).
1 0
The " " " " indicator to the left beside the time
sensor will light up.
A red dot will light up continuously beside
the heat setting display to indicate that the
timer is active.
4. Press the "+" sensor (10) and the "-" sen-
sor (11) at the same time to set the timers
0 0
to " " ".
5. Press the "+" sensor to set the desired
number of minutes after which the cook-
ing zone is to switch off.
The display showing the number of min-
utes set will flash for a few seconds, during
which time that number can be adjusted,
and will then light up normally.
When the time that has been set expires,
you will hear a signal tone and the cooking
zone will be shut off.
If other cooking zones are likewise
switched on, these will remain active.
6. To shut off a signal tone early, press ei-
ther the "+" sensor button or the "-" sen-
sor button.
The maximum timer setting is 99 min-
utes.
You can switch off all cooking zones using
a timer.
A red dot will light up continuously beside
the heat setting display for the selected
cooking zone to indicate that the timer for
this cooking zone is active.
Change the time in the cooking
time limit
You can change a shut-off time that has al-
ready been set at any time.
1. Press the sensor for the cooking zone for
2. Touch the timer sensor (7).
3. To set the indicator to "
When the shut-down function is activated, a
red dot will light up continuously next to the
heat setting display for the selected cooking
zone.
10 10 1
which the timer has been set.
A dot will light up beside the heat setting
display for the cooking zone.
The heat setting display for the selected
cooking zone will blink.
The remaining number of minutes until
shut-down will flash for a few seconds. The
setting can be changed while this indica-
tor is flashing. Afterwards, the indicator will
again be lit normally.
0
" " and switch off
the timer, simultaneously press the "+"
sensor (10) and the "-" sensor (11).